System 3 Service Bulletin 005

001: Lettering, Centering and Alignment for System 3 Machines.

002: Setting Ball Nut Preload on System 2 & System 3 Machines.

003: Setting System 3 Printwheel Belt Tension.

004: Pre-load Adjustment for System 3 Spindle Bearings.

005: Diagnosing System 3 Machine Problems.

006: Setting up the Cloth Feeder.

007: System 3 Printwheel Drive Sheave Positioning.

008: Setting Auxillary Sensors on the System.

009: Spindle bearing lubrication for System 2 & System 3.

010: Setting Wheel Tilt Positions on System 3.

011: System 3 Printwheel and Font Table Selection.

012: "Over Travel" Theory and Use.

Flesher: Technical Support System 3 Service Bulletin 005: Diagnosing SYSTEM 3 Machine Problems Occasionally, problems occur with the System 3 machine that require determining whether the machine or the computer is at fault. Your MOD35 software includes a program which facilitates the troubleshooting process by generating a file of diagnostic comments. To generate this file: Run the program S3COMMXX, then "Stamp" one of two titles using the range stamp (Shift-F4) feature. Use small titles containing just a few characters. (The stamper will not move; instead, the stamper control commands will be written to a diagnostic log file named MACH.LOG which will be placed in the current directory.). Print the contents of the diagnostic log file and FAX the printout to Flesher Corporation at (719) 633 - 1111 ext: 50 or email: larry@fleshercorp.com.